Electrical Requirements For 60 Hertz Systems; Required Electrical Service - Xerox DocuTech 6100 Install Manual

Select and prepare an installation site

Electrical requirements for 60 hertz systems

4-10
NOTE: The power lines that provide electrical service for the
DocuTech printer can not be shared with other devices.
The type of electrical service that is installed depends on the
existing electrical service, and the power cord configuration that
works for your location.
All configurations require a 110 VAC, 15 amp receptacle for the
outlet strip that provides receptacles for the controller and its
peripheral devices (monitor, modem, cdrom drive, and tape
drive).
A single power cable is the default configuration for the
DocuTech 6100, 6115, or 6135 printer.
This configuration consists of one single-phase (two lines and
neutral, plus ground, four wire system, 50 amp outlet.
• Line to neutral: 120V (nominal); range 107 VAC to 127 VAC
• Line to neutral: 240V (nominal); range 205 VAC to 254 VAC
The following kit is available through your Xerox representative:
600S3779: for the 50 amp receptacle kit.

Required electrical service

The following electrical service options are available:
• Only available in DMO Latin 3-phase, single power cord
configuration
This configuration consists of one 120/208 VAC, 4 wires plus
ground, 50 amp, 3-phase power cord. The following kits must
be ordered through your Xerox representative:
– 600K59310: for a wall mounted receptacle.
– 600K59300: for a drop receptacle.
– 98K59570: contains a 3-phase, single power cord and
associated components.
• For the USA and Canada only: 2-phase, dual power cord
configuration
DocuTech 61xx Installation Planning Guide