Pantum CM2100 Series User Manual page 7

CAUTION - POTENTIAL INJURY: Do not cut, twist, bind, crush, or place heavy objects on the power
cord. Do not subject the power cord to abrasion or stress. Do not pinch the power cord between objects
such as furniture and walls. If any of these things happen, it could result in a risk of fire or electrical
shock. Inspect the power cord regularly for signs of such problems. Remove the power cord from the
electrical outlet before inspecting it.
CAUTION - SHOCK HAZARD: To avoid the risk of electrical shock, make sure that all external
connections (such as Ethernet) are properly installed in their marked plug-in ports.
CAUTION - SHOCK HAZARD: To avoid the risk of electrical shock, if you are accessing the
controller board or installing optional hardware or memory devices after setting up the printer, turn the
printer off, and unplug the power cord from the electrical outlet before continuing. If you have any other
devices attached to the printer, turn them off as well, and unplug any cables going into the printer.
CAUTION - SHOCK HAZARD: To avoid the risk of electrical shock when cleaning the exterior of
the printer, unplug the power cord from the electrical outlet and disconnect all cables from the printer
before proceeding.
CAUTION - POTENTIAL INJURY: If the printer weighs more than 18 kg, then it requires two or
more trained personnel to lift it safely.
CAUTION - POTENTIAL INJURY: When moving the printer, follow these guidelines to avoid
personal injury or printer damage:
• Make sure that all covers and trays are closed.
• Turn off the printer, and then unplug the power cord from the electrical outlet.
• Disconnect all cords and cables from the printer.
• If the printer has casters on its base, then carefully move it to the new location. Use caution when
passing over thresholds and breaks in flooring.
• Always use the handholds on the printer to lift it.
• Any cart used to move the printer must have a surface able to support the full footprint of the printer.
• Keep the printer upright.
• Avoid violent vibrations when moving.
• Make sure that your fingers are not under the printer when you set it down.
• Make sure that there is adequate clearance around the printer.
CAUTION - HOT SURFACE: The inside of the printer might be hot. To reduce the risk of injury by a
hot component, allow the surface to cool before touching it.
CAUTION - HOT SURFACE: Some parts of the printer are still in high temperature within a short
time after use. To prevent burns, please don't directly touch places labeled with high temperature
warning in contact with internal components after opening the printer's front or rear cover.
CAUTION - PINCH HAZARD: To avoid the risk of a pinch injury, use caution in areas marked with
this label. Pinch injuries may occur around moving parts, such as gears, covers, trays, and covers.
VI