Receiving A Call; Figure 10: Incoming Call Pop-Up - Codan Envoy Control Getting Started Manual

O
PERATING THE TRANSCEIVER
C
ALLING

Receiving a call

Some calls that are addressed to your station are handled automatically
by your transceiver. It will either respond automatically with the
information requested in the call that it received (Get Position, Get
Status, Channel Test, or ALE Sounding call), or receive the message
(Message or Send Position call). The remaining call types (Selective,
Phone, and Emergency) sound an alarm at your station.
For incoming ALL, ANY, Group Selective, and Wildcard calls to
multiple control points, any control point that has a matching address
will receive the call, if permitted. You may have to switch off mute and
change the mute type to be able to hear the conversation.
Selective and Phone calls sound an alarm that is similar to a telephone
ringing. An Emergency call sounds a hee-haw alarm.
To answer an incoming call:
1

Figure 10: Incoming call pop-up

control point with
control of a call
60
Listen for an incoming call tone.
An incoming call pop-up shows information on the type of call,
the address of the caller, the time of the call, and the channel
used.
After the period set in Settings > Calling > General > In
Call Timeout has lapsed in the transceiver, the incoming call
pop-up changes to the missed call pop-up.
control point without
control of a call
E ™ T
NVOY RANSCEIVER
G S G
ETTING TARTED UIDE