Entering A Self Address - Codan Envoy Control Getting Started Manual

1
Adding channels to a scan table
To add channels to a scan table:
1
1
1
1
1

Entering a self address

A self address is used by other stations to call your station. For example,
if the self address of your station is 1234, operators at other stations
enter the address 1234 when they want to make a call to you.
To enter a self address:
1
1
E ™ T
NVOY RANSCEIVER
Do one of the following:
• If you want to scan all of the channels in the transceiver
that have a USB mode, press
from Entering a self address on page
• If you want to choose the channels and modes that you
want to scan, press
Adding channels to a scan table on page
Press or to scroll to the channel that you want to add, then
press OK.
Press or to select the mode that you want to use.
Select more channels, as required.
Press (Save) to add these channel selections.
Continue from Entering a self address on page
Enter the address that you want to use.
You can enter up to six digits, or you may leave the self address
blank if a peripheral device has its own self address set.
NOTE:
Addresses ending in one or more 9 or 0 digits have
a special function in Selcall HF networks.
Press (Save) to save the information.
G S G
ETTING TARTED UIDE
U
SING THE WIZARD
U
SING THE WIZARD
(Yes), then continue
23.
(No), then continue from
23.
23.
23