Codan Envoy Control Getting Started Manual page 170

I
NSTALLING THE TRANSCEIVER
O
VERVIEW OF MOBILE STATIONS
Mounting the speaker
To mount the speaker:
1
1
Mounting the handset and speaker connector
To mount the handset and speaker connector:
1
Mounting the RFU
CAUTION: If you are transferring a fixed station to a mobile station
To mount the RFU:
1
1
158
Secure the mounting cradle to the surface with at least two
screws.
Ensure there is sufficient space at the rear for the cable.
Attach the speaker to the cradle with the two screws and rubber
washers.
Use cable ties or screws to secure the handset and speaker
connector in a suitable location.
and you have attached rubber feet to the bottom of the
RFU, you must remove the rubber feet before installing it
into the mounting cradle.
Secure the mounting cradle to the surface with at least four
screws, one in each corner of the cradle.
NOTE:
Ensure there is sufficient space at the rear of the
cradle to clear the RFU heatsink.
If the key is locked to the base of the cradle, flip the key away
from the base until it can be rotated (see
the key in a counterclockwise direction.
E ™ T
NVOY RANSCEIVER
Figure 46), then rotate
G S G
ETTING TARTED UIDE