Setting The Types Of Connections Between Modules; Adding A Channel - Codan Envoy Control Getting Started Manual

Setting the types of connections between modules

NOTE:
The types of cables used to connect the modules in your system affect
whether or not the control point can power down and power up the RFU.
NOTE:
To set the types of connections:
1

Adding a channel

NOTE:
To add a channel:
1
1
1
1
1
E ™ T
NVOY RANSCEIVER
This step in the wizard is shown if your control point is a
desk console, or a Mk 2 handset connected via an Envoy
SmartLink.
For detailed connection diagrams, please see the
Reference Manual.
Do one of the following:
• If at least one connection between the control point and
the RFU uses an Ethernet cable, press
continue from
• If all connections between the control point and the RFU
use Codan control cables, press
from Adding a channel on page
This step in the wizard is shown if you are permitted to
add channels.
Press (Yes) to add a channel, if required.
Enter the name that you want to use for the channel.
to move to the Tx entry.
Press
Enter the transmit frequency that you want to use for this channel
(in kHz, with up to three decimal points or 1 Hz resolution).
to move to the Rx entry.
Press
The Rx entry is automatically filled with the transmit frequency.
G S G
ETTING TARTED UIDE
Adding a channel on page
21.
U
SING THE WIZARD
U
SING THE WIZARD
(Yes), then
21.
(No), then continue
21