When The Envelope Print Job Is Finished; Recommended Image Area For Envelopes - Xerox 4215 Operator's Manual

<

When the Envelope Print Job is Finished

RECOMMENDED IMAGE AREA
FOR ENVELOPES
Refer to the section, "When the Manual Print
Job Is Finished," earlier in this chapter for
the steps to reset the manual feed and envelope
size settings back to their original settings.
The varying number of material thicknesses that
are encountered in different areas of an
envelope has a significant impact on print
quality. Acceptable print quality can only be
assured when printing in those areas where
there are only two thicknesses of material.
Figure 4-6, the upper diagram shows the varying
material thicknesses that are present on a
commercial #10 envelope.
The lower diagram in Figure 4-6 defines the
recommended image area.
for the following explanations:
Recommended image area:
F
area should be used for printing the address
of the recipient.
achieved in this area.
Shaded areas:
F
area to be used for the address.
recommendation is based on the requirements
of high-speed optical character recognition
cut top 2"
See the lower diagram
The cross-hatched
Optimum image quality is
These areas represent the
cut 1">
DIIIIIIIIHHHHHHHHIIIIIIIIIIIII
Operator Guide 4-19
In
This