Paper Tray Fails To Close; Printing Takes Too Long; Print Job Fails To Print - Xerox B210DNI User Manual

Paper Tray Fails to Close

Probable Causes
Debris or an object is blocking the paper
tray.

Printing Takes Too Long

Probable Causes
The printer is set to a slower printing
mode. For example, the printer is set to
print on Heavy weight paper.
The printer is in power saver mode.
The way the printer was installed on the
network.
The job is complex.
The print-quality mode in the print
driver is set to High Resolution

Print Job Fails to Print

Probable Causes
The printer has an error.
The printer is out of paper.
The toner cartridge is empty.
The power cord is not plugged into the
outlet correctly.
Solutions
Remove the debris or object that is blocking the paper tray.
Solutions
It takes more time to print on certain types of special paper.
Ensure that the paper type is set properly in the print driver.
It takes time for printing to start when the printer is exiting power
saver mode.
Determine if a print spooler or a computer sharing the printer is
buffering all print jobs, then spooling the jobs to the printer.
Spooling can slow print speeds. To test the speed of the printer,
print information pages, refer to
prints at the rated speed of the printer, check for a network or
printer installation issue.
Wait for the document to finish printing.
In the print driver, change the print-quality mode to Standard.
Solutions
• To clear the error, power off the printer, then power it on again.
• If the error persists, contact a service representative.
Load paper into the tray. For details, refer to
Replace the empty toner cartridge. For details, refer to
the Toner Cartridge.
Power off the printer, confirm that the power cord is plugged in
correctly to the printer and the outlet, then power on the printer.
General Troubleshooting
Information Pages. If the page
Loading Paper.
Replacing
Xerox B210 Printer
®
User Guide
136