Maintenance; Fuser Replacement; Before An Extended Shutdown - Xerox 4215 Operator's Manual

<

MAINTENANCE

This section gives you procedures to maintain
your printer for optimum printer performance.

Fuser Replacement

For optimum quality and to maintain warranty
requirements, replace the fuser after every
200,000 pages of printing.
determined from the Start Page on the Hardware
Status Report.
Report, follow the procedures in the "Hardware
Status Report" section found in Chapter 4.
B
B

Before an Extended Shutdown

When you will not be using the printer for more
than one week, do the following:
1. Switch the printer off at the power switch.
2. Unplug the power cord.
3. Remove the paper trays and store them in a
cut top 2"
To print the Hardware Status
WARNING: Always power off and unplug
the printer before beginning service
WARNING: The fuser area can be very
hot. Power off the printer for a
minimum of 30 minutes before the fuser
place that is less susceptible to moisture
XEROX 4219/MRP Mid Range Systems Printer
XEROX 4215/MRP Mid Range Systems Printer
DIIIIIIIIHHHHHHHHIIIIIIIIIIIII
Operator Guide
Page count can be
cut 1">
5-41