Xerox 4215 Operator's Manual page 128

<
3-10 Configuring the Interface Card
Step 6. After the printer powers up, the green test
light flashes two times.
after the green light flashes and release the
test button.
The Start Page (see Figure 1-26) prints (if
enabled), followed by a page with the following
single line item:
The printer emulation is now stored in
nonvolatile memory.
Printer Address
emulation is set, but the printer address is
not.
Step 9. Connect the twinaxial printer cable.
Step 10. Switch the printer on again.
The Start Page (see Figure 1-26) prints (if
enabled), followed by the Twinax Configuration
Report.
Step 11. Verify that the printer address has been set
correctly by checking the Line Set Up field on
the Twinax Configuration Report.
XEROX 4219/MRP Mid Range Systems Printer
XEROX 4215/MRP Mid Range Systems Printer
cut top 2"
CURRENT EMULATION IS 5256
In the second part of the process you set
Wait ten seconds
At this point the printer
cut 1">
DIIIIIIIIHHHHHHHHIIIIIIIIIIIII
For this