Print Language; Printer Language (Twinax Only) - Xerox 4215 Operator's Manual

<

Print Language

The default print language is determined by the
placement of a shunt over a 3-pin jumper (ST2).
The illustration below shows the jumper
configuration.
with the jumper in the standard configuration.
The shunt should always be placed over the two
pins closest to the edge of the interface card.
DO NOT move the jumper shunt.

Printer Language (twinax only)

Figure 3-5 shows the printer language switch
settings.
configured by your Xerox service representative
cut top 2"
The printer works properly only
ST2
The default language setting is
XEROX 4219/MRP Mid Range Systems Printer
XEROX 4215/MRP Mid Range Systems Printer
DIIIIIIIIHHHHHHHHIIIIIIIIIIIII
Operator Guide
The jumper
cut 1">
3-5