Setting The Coax And Twinax Defaults - Xerox 4215 Operator's Manual

<
Chapter 3
CONFIGURING THE
INTERFACE CARD
This chapter describes:
F
F
F
F
F
The default settings described in this chapter
are used whenever a print request does not set
them.
For information on setting defaults through the
Function Selection via Line (FSL) commands,
refer to the Xerox Twinax Command Reference and
Xerox Coax Command Reference .
SETTING THE COAX AND
TWINAX DEFAULTS
Figure 3-1 illustrates the top view, and Figure
3-2 illustrates the side view of the coax
interface card.
view of the twinax interface card.
cut top 2"
Configuring the coax interface card for
default page size and print language
settings
Configuring the twinax interface card for
default printer language, page size, print
language, printer emulation, and device
address settings
Configuring the twinax IPDS interface card
for the default printer emulation setting
Printing the Other I/O Log
Dual printer lines connected to the
interface card
Figure 3-3 illustrates the top
XEROX 4219/MRP Mid Range Systems Printer
XEROX 4215/MRP Mid Ragne Systems Printer
cut 1">
DIIIIIIIIHHHHHHHHIIIIIIIIIIIII
3-1
Figure 3-4