Tcp/Ip - Xerox WorkCentre 4118 System Administration Manual
Xerox workcentre 4118: user guide
Hide thumbs
Also See for WorkCentre 4118:
- Quick use manual (146 pages) ,
- Brochure & specs (4 pages) ,
- Quick reference manual (2 pages)
Table of Contents
Advertisement
TCP/IP
Use these instructions to install the device on a TCP/IP network using CentreWare Internet
Services.
Installation Procedure
There are two stages required to install the device on a TCP/IP network using CentreWare
Internet Services:
Configure the WorkCentre 4118
Test Print
Configure the WorkCentre 4118
NOTE: The TCP/IP settings for the device will have been setup when completing
the Enabling CentreWare Internet Services section.
To complete the installation of the device, perform these steps:
Enable CentreWare Internet Services (see "Enabling Internet Services" on page 7-5).
1
At the CentreWare Internet Services Home Page for the WorkCentre 4118, select the
2
[Properties] tab.
Select the plus symbol [+] to the left of the Connectivity folder in the Properties frame, and
3
then select the [+] symbol to the left of the Protocols folder.
Select [TCP/IP] and check the Protocol Configuration details are correct. If any of the
4
details are incorrect then enter the correct information.
In the Physical Connection field, Ethernet will be the default setting.
5
Page 7-10
This procedure explains how to use CentreWare Internet Services to
configure the device.
A print job should be submitted to ensure the device has been installed and
configured correctly.
Select the checkbox to enable TCP/IP.
Enter the [Host Name].
Choose the [IP Address Resolution] required.
Xerox WorkCentre 4118 System Administration Guide
Advertisement
Table of Contents
