Appletalk Installation; Installation Procedure; Network Communication Setup - Xerox WorkCentre 4118 System Administration Manual
Xerox workcentre 4118: user guide
Hide thumbs
Also See for WorkCentre 4118:
- Quick use manual (146 pages) ,
- Brochure & specs (4 pages) ,
- Quick reference manual (2 pages)
Table of Contents
Advertisement
AppleTalk Installation
Installation Procedure
There are two stages required to install the WorkCentre 4118 on an Appletalk network:
Network Communication Setup
Print Driver Installation
Test Print
Network Communication Setup
This procedure is used to setup the network communication parameters of the WorkCentre
4118.
At the WorkCentre 4118, perform these steps:
HINT:
WorkCentre 4118, refer to the Internet Services chapter for instructions.
Connect the device to the network outlet or cable.
1
Press the [Machine Status] button.
2
3
Press
Admin Tools displays and press
[Enter].
If the System Admin Tools have
been passcode protected, type in
the password and press [Enter].
Xerox WorkCentre 4118 System Administration Guide
This requires the WorkCentre 4118 to be setup for Appletalk.
A test print should be submitted to ensure the WorkCentre 4118 has been
installed and configured correctly.
Xerox CentreWare Internet Services can also be used to configure the
or
until System
System Admin Tools
[Passcode Protect]
Page 5-3
Advertisement
Table of Contents
