Interrupting A Print Job - Xerox 6204 Copy/Scan Operation Manual

Interrupting a Print Job

You can interrupt a print job to make a high priority copy. The interrupted print job will
resume after the copy job finishes.
1
Press the <Interrupt> button on the control panel
while the print job is processing.
The <Interrupt> button will illuminate and stay lit
throughout the interrupt job. Typically, no more than
two prints will exit the machine before printing stops.
2
When the suspended job stops, the [Copy]
screen will appear.
3
Select the required copy settings from the [Basic
Copy], [Image Quality], and [More Features]
screens.
4
Enter the copy quantity (1 to 999), using the
numeric keypad.
5
Scan the original(s).
The copy job will run.
6
When the copy job is finished, press the <Interrupt> button again.
The interrupt mode will be cancelled, the <Interrupt> button will go out, and the suspended print
job will resume printing.
If you forget to press the <Interrupt> button to cancel the interrupt mode, it will be
Note:
canceled automatically after the default [Print Interrupt] timer times out.
The print interrupt timeout period may be changed from the 60 second default to as long
as 99 minutes. This is accomplished by selecting the [Setup] button on the control panel,
then selecting the [Timers] feature, and finally, [4. Print interrupt]. Use either the numeric
keypad or the scroll buttons to select a different timeout period.
Xerox 6204 Wide Format Solution

Interrupting a Print Job

<Interrupt>
57
3