Exiting The Power Saver Mode; System Power On Procedure - Xerox 6204 Copy/Scan Operation Manual

Exiting the Power Saver Mode

The Power Saver mode may be exited either manually or automatically.
Manual Method: With the machine in the Power
Saver mode, press the illuminated <Power
Saver> button. The button's indicator light will
extinguish, the touch screen will display the
message Warming Up, and the machine will
begin its warm up cycle.
Automatic Method: The machine will exit the
Power Saver mode when it detects a print job in
the active queue.

System Power On Procedure

The procedure below describes the process for powering up the system from a cold
start, that is, it assumes that both the printer and the controller are powered down
completely.
1
Move the printer circuit breaker switch up, to the
On [ ] position.
|
2
Move the printer power switch to the On [
position.
3
Press the power button on the front of the
controller.
The power button lamp will illuminate. After about one-
half minute, the control panel will display the message
Printer Warming Up. The machine will be print-ready
in about three minutes.
Xerox 6204 Wide Format Solution
Powering the System On/Off
]
|
2 Power Switch
1 Circuit Breaker
3 Power Button
<Power Saver>
2
29