Tray 5 Paper Jams; Transfer Module Paper Jams - Xerox DocuColor 240 Supplementary Manual

Tray 5 Paper Jams

This section describes how to clear paper jams that occur in Tray 5 (Bypass).
1. Open the Tray 5 Cover. Inspect the paper feed entrance area and remove
any jammed paper.
2. When two or more sheets of paper are loaded, remove all of the sheets
from the tray.
3. Close the Tray 5 Cover.
NOTE: If paper is torn, check for any torn pieces of paper inside the
machine.
4. Fan the paper you removed making sure that all four corners are neatly
aligned.
5. Insert the paper into the Tray with the printing side facing up until its lead
edge lightly touches the paper feed entrance.

Transfer Module Paper Jams

This section describes how to clear paper jams that occur in the Transfer Module
area.
1. Make sure that the machine has stopped. After the machine has stopped,
open the front door.
2. Turn Handle 2 to the right until it is in the horizontal position, then pull out
the transfer module.
Warning: Never touch a labeled area (found on the fuser unit or
nearby) indicating "High Temperature" and "Caution".
You may get burned.
3. Remove the visible jammed paper.
4. Move Handle 2a to the right and remove any jammed paper.
5. Pull down Handle 2b and remove the jammed paper.
6. Return Handle 2a and Handle 2b to their original position. Push in the
transfer module completely and turn Handle 2 to the left.
7. Close the front cover.
DocuColor 240/250 Training and Information Guide
DocuColor 240/250
172