Safety Inspection; Disposal; Safety Symbols; Data Backup - Fronius TWIN Push Operating Instructions Manual

Safety Inspec- The manufacturer recommends that a safety inspection of the device be per-
tion
formed at least every 12 months.
The manufacturer recommends calibrating power sources within the same 12-
month interval.
A safety inspection by a certified electrician is recommended:
-
-
-
-
For the safety inspection, follow the appropriate national and international
standards and guidelines.
You can obtain more information about the safety inspection and calibration
from your service center. The service center will provide the necessary docu-
ments upon request.

Disposal

Waste electrical and electronic equipment must be collected separately and re-
cycled in an environmentally sound manner in accordance with the European Dir-
ective and national law. Used equipment must be returned to the distributor or
through a local authorized collection and disposal system. Proper disposal of the
used device promotes sustainable recycling of material resources. Failure to ob-
serve this may lead to potential health/environmental impacts.
Packaging materials
Separate collection. Check your municipality's regulations. Reduce the volume of
the box.

Safety symbols

Devices with the CE label satisfy the essential requirements of the low-voltage
and electromagnetic compatibility directive (e.g., relevant product standards of
the EN 60974 series).
Fronius International GmbH declares that the device complies with Directive
2014/53/EU. The full text of the EU Declaration of Conformity is available on the
following website: http://www.fronius.com
Devices marked with the CSA test mark satisfy the requirements of the relevant
standards for Canada and the USA.

Data backup

The user is responsible for backing up any changes made to the factory settings.
The manufacturer accepts no liability for any deleted personal settings.

Copyright

Copyright of these Operating Instructions remains with the manufacturer.
Text and illustrations were accurate at the time of printing. Fronius reserves the
right to make changes. The contents of the Operating Instructions shall not
provide the basis for any claims whatsoever on the part of the purchaser. If you
have any suggestions for improvement, or can point out any mistakes that you
have found in the Operating Instructions, we will be most grateful for your com-
ments.
18
After changes
After alterations
After repair, care, and maintenance
At least every 12 months