Fitting The Wirefeeding Hoses And Inner Liners; Inserting The Inner Liner Into The Torch Hosepack - Fronius TWIN Push Operating Instructions Manual

Fitting the wirefeeding hoses and inner liners

Inserting the in- For TWIN Push/Pull systems without wire buffers
ner liner into the
torch hosepack
1
2
3
4
5
6
7
132
Disconnect the wirefeeding hose from the robot wirefeeder (press white but-
ton)
Fit the collet
Insert the inner liner until it is visible at the sight hole of the drive unit
Cut the inner liner flush to length
Fit the inlet nozzle to the brass section according to the basic kit
Screw the brass section with inlet nozzle onto the collet
Reconnect the wirefeeding hose (press the white button if necessary, the but-
ton must pop out again)