Table of Contents
Advertisement
-
-
-
-
The housing screws provide the ground conductor connection for earthing the
housing parts.
Only use original housing screws in the correct number and tightened to the spe-
cified torque.
Safety inspec-
The manufacturer recommends that a safety inspection of the device be per-
tion
formed at least once every 12 months.
The manufacturer recommends that the welding system be calibrated during the
same 12-month period.
A safety inspection should be carried out by a qualified electrician
-
-
-
-
For safety inspections, follow the appropriate national and international stand-
ards and directives.
Further details on safety inspection and calibration can be obtained from your
service centre. They will provide you with any documents you may require, on re-
quest.
Disposal
Waste electrical and electronic equipment must be collected separately and re-
cycled in an environmentally responsible manner in accordance with the EU Dir-
ective and national law. Used equipment must be returned to the distributor or
through a local, authorised collection and disposal system. Proper disposal of the
old device promotes sustainable recycling of material resources. Ignoring this
may lead to potential health/environmental impacts.
Packaging materials
Collected separately. Check your municipality's regulations. Reduce the volume
of the box.
Safety symbols
Devices with the CE mark satisfy the essential requirements of the low-voltage
and electromagnetic compatibility directives (e.g. relevant product standards of
the EN 60 974 series).
Fronius International GmbH hereby declares that the device is compliant with
Directive 2014/53/EU. The full text on the EU Declaration of Conformity can be
found at the following address: http://www.fronius.com
Devices marked with the CSA test mark satisfy the requirements of the relevant
standards for Canada and the USA.
Use only original spare and wearing parts (also applies to standard parts).
Do not carry out any modifications, alterations, etc. to the device without the
manufacturer's consent.
Components that are not in perfect condition must be replaced immediately.
When ordering, please give the exact designation and part number as shown
in the spare parts list, as well as the serial number of your device.
after any changes are made
after any additional parts are installed, or after any conversions
after repair, care and maintenance are carried out
at least every twelve months.
15
Advertisement
Table of Contents
