Before You Begin - Xerox DocuColor 5750 Administrator's Manual

1
1-11 DocuColor on the network

Before you begin

The following steps should be completed before you configure the DocuColor and the
workstations that will print to the DocuColor. A service technician will have
performed some initial installation.
T D C
O PREPARE FOR OCU OLOR INSTALLATION
1. Print a copier test page to make sure the copier is functioning normally.
2. Turn off the copier and connect the interface cable from the copier to the
DocuColor.
While the DocuColor is turned off, verify that the SCSI terminator is installed on the
SCSI connector on the back of the DocuColor.
3. To confirm this connection, turn on the copier and the DocuColor and print a Test Page
from the Control Panel.
To print a Test Page, press the Menu button on the Control Panel to display the
Functions menu. (See "DocuColor Control Panel" on page 2-3.) Choose Print Pages,
and then Test Page.
4. With both the copier and the DocuColor turned off, connect the network cable to the
DocuColor, as described in the next section.
The network should already be installed and operational.
5. Turn on the copier and then the DocuColor.
6. Prepare network servers to share DocuColor user software and to enable networked
users to print to the DocuColor, and proceed to Setup.
See Chapters 2 and 3 for details.
: