Xerox DocuColor 5750 Administrator's Manual page 110

4
4-4 Administering the DocuColor
After this Setup screen:
Frame Type selection
(Network Protocol Setup/
IPX/SPX Setup)
Token Ring Setup
Frame Type selection
(Network Protocol Setup>
IPX/SPX Setup)
Enable NDS
(Network Service
Setup>PServer Setup>NDS
Setup)
This message:
Can't detect Token Ring
hardware.
Token Ring hardware
not installed or
not functioning.
Invalid frame size.
Warning! IPX network
number is zero.
Can't autodetect the ring
speed. No device on ring.
Invalid frame size.
Warning! IPX network
number is zero.
No NDS trees found.
Means:
DocuColor queries the Token Ring hardware. Error
indicates that some components are not installed, are not
installed correctly, or not installed in the correct device. An
unsupported Token Ring board may be in use. Check with
your authorized service/support center.
The network hub is not connected to a Novell machine
when the DocuColor tries to bind.
No other IPX machine can be found on the network, or
the network hub is not connected to the network, when
the DocuColor tries to bind. When this occurs, the
network number defaults to zero.
The DocuColor is trying to detect the current ring speed,
but it is the only machine on the Token Ring network.
Connect another machine to the Token Ring network first,
before connecting the DocuColor.
The network hub is not connected to a Novell machine
when the DocuColor tries to bind.
No other IPX machine can be found on the network, or
the network hub is not connected to the network, when
the DocuColor tries to bind. When this occurs, the
network number defaults to zero.
No NDS trees were found on the Novell network. Check
that IPX frame types are properly set.