Xerox DocuColor 5750 Administrator's Manual page 32

2
2-4 Setting up the DocuColor
4. At the startup message, press any button.
For software
update or setup,
press any key.
5. Choose Run Setup to access all setup menus.
Run Setup
Install Software
Format Disk
Start Up
6. Press the line selection button to choose a Setup menu or command.
Exit Setup
Server Setup
Network Setup
Printer Setup
Setup
7. Choose setups in the same order as they appear in the menu: Server Setup, Network
PS Setup
Color Setup
Job Log Setup
Calibration
Setup
Change Password
Clear Server
Setup
T
O ACCESS
1. Make sure the DocuColor is connected to the copier and connected to the network you
2. Turn on the DocuColor.
3. At the startup message, press any button.
4. Continue with step 5 from the previous procedure.
The Start Up screen is displayed.
The Install Software and Format Disk commands are for service technicians.
Press the down arrow to view the second and third screens of the main Setup
menu.
Setup, Printer Setup, PS Setup, Color Setup, and then Job Log Setup.
The sequence is important for first-time Setup.
Later, just go directly to the menu you want to change. However, if you make
changes in Network Setup, you may need to change some settings in Printer Setup
as well.
If you make changes in Server, Network, or Printer Setup, you'll need to
NOTE:
update the system configuration by opening and saving the other Setups even if
you haven't changed any other settings.
S D C
ETUP WHEN THE OCU OLOR IS OFF
will use.
The startup diagnostics are performed.
Review the settings described in this chapter. For more information on calibration, and
on Control Panel screens other than those in Setup, see the User Guide.
: