Quick Path To Installation - Xerox DocuColor 5750 Administrator's Manual

1
1-4 Connecting to the Network

Quick path to installation

The diagrams in the following pages show typical systems that can be used for printing
and for using the DocuColor utilities. To use the diagrams, find the page with your
preferred platform and network type. Then look up the setup procedures in the pages
and books referred to in the keys.
The diagrams describe devices that use the supported networking protocols. They are
logical diagrams and are not intended to describe the physical arrangement (topology)
of devices on the network. A variety of physical arrangements is possible with each
logical arrangement. For example, twisted pair Ethernet networks commonly use a star
configuration around a hub, rather than a bus arrangement. The design of physical
networks is beyond the scope of this manual.
If the network uses more than one protocol or more than one type of workstation,
combine the setups listed for each component of your system. Note that multiple
protocols (shown in the diagrams as parallel lines) can run on the same cable. A solid
connection from the DocuColor with an arrow indicates that other supported network
types can be operational at the same time.
The networking functionality outlined in this section is available on both Ether-
N :
OTE
net and Token Ring networks. A Token Ring card is required for connection to a
Token Ring network. Token Ring drivers are included with DocuColor system soft-
ware. See Appendix A for details.
The protocols used in these diagrams are indicated as follows:
IPX (Novell)
AppleTalk
TCP/IP (lpd or
nbt)
Parallel
Other