Assembly And Setup; Parts And Materials; Siting Requirements; Unpacking - Nautilus Instinct Multi-Press Owner's Manual

A
SSEMBLY AND

PARTS AND MATERIALS

The following parts are included with the NAUTILUS INSTINCT MULTI-PRESS:
1 Frame, Weight Stack
2 Frame, Main
3 Crossbeam, Upper
5 Support, Leverage Arm (factory installed)
6 Leverage Arm
9 Shroud, Lower, Front
12 Cushion, Seat
14 Crossbeam, Lower
15 Shaft, Leverage Arm
17 Cushion, Back
20 End Cap
25 Support, Weight Stack
26 Weight, 10lb
27 Plate, Top, Weight Stack
28 Shroud, Lower, Rear
29 Shroud, Upper
30 Selector Pin
T R
OOLS EQUIRED
Most NAUTILUS INSTINCT machines can be assembled using the following tools:
Metric Hex Key Wrenches - 2.5mm, 5mm, 6mm,

8mm, 10mm
Metric Open-End Wrenches - 10mm, 15mm,

17mm
Metric Ratchet Socket Wrench Set (including

17mm socket)
Torque Wrench

Your INSTINCT MULTI-PRESS includes a hex key set and combination open-end wrench.

SITING REQUIREMENTS

Your INSTINCT MULTI-PRESS requires approximately 32 square feet of floor space to ensure safe operation of the unit.

UNPACKING

Your INSTINCT MULTI-PRESS is shipped in one or more shipping cartons. Each carton will generally contain one
subassembly of the entire unit. To unpack:
Remove the shipping straps from the outside of each shipping carton.

Open the top of each carton and fold back all four flaps.

Remove the packing materials, foam inserts, and ALL parts from each shipping carton. Keep the contents of each carton

in a separate area to facilitate assembly. To ensure personal safety during assembly, place all packing materials outside
the assembly area.
Verify that all parts listed above are included in your shipment.

Take time now to enter your INSTINCT MULTI-PRESS serial number in the space below. If parts are missing, or if you have
any operational questions, please call Nautilus's Service department at (800) 503-1221; have your serial number ready.
Serial No. __________________________________________
6
S
ETUP
1
1
1
1
1
1
1
1
1
1
2
2
7
1
1
2
1
NAUTILUS INSTINCT MULTI-PRESS O
31 Retainer, Belt
33 Guide Post, Weight Stack
38 Cap, Rubber
39 Nut, Tapped Hole
44 Belt
46 Screw, Button Head Socket Cap, 10X130M
48 Screw, Button Head Socket Cap, 10X80M
50 Screw, Button Head Socket Cap, 10X35M
51 Screw, Button Head Socket Cap, 10X30M
52 Screw, Button Head Socket Cap, 8X20M
53 Screw, Flat Head Socket, 10X30M
54 Screw, Retaining
62 Lock Nut, Nylon Insert, 10M
65 Washer, 11M
66 Washer, 9M
73 Weight, 5lb
74 Weight, 15lb
Channel Lock Pliers

Vice Grip Pliers

Rubber Mallet

Phillips Head Screwdriver - #2

2
2
2
6
1
6
2
6
2
6
2
2
8
24
6
6
6
'
M
WNER S ANUAL