Replacing The Storage Media; Fig. 27 Battery Change; Table 13 Technical Data Of The Battery - Beckhoff CP22 Series Manual

Maintenance
Table 13: Technical data of the battery
Battery type Electrical properties (at 20 °C)
Nominal voltage Nominal capac-
CR2032
Chapter 7.2 Maintenance [} 39] shows where the battery is located.
To replace the battery, follow the steps below as shown in Figure 27:
1. Loosen and remove the M4 screw and the cover (section A).
2. Pull the battery out of the panel PC with needle-nose pliers (section B).
3. Insert the new battery into the PC by hand. Pay attention to the correct polarity. The negative pole of the
battery must face the display.
A
Fig. 27: Battery change
To dispose of the battery, remove it, tape off the poles and put it in the battery disposal.
7.2.2

Replacing the storage media

Chapter 7.2 Maintenance [} 39] shows where the storage media are located.
For new storage media, please contact your Beckhoff Sales only. Hard disks from Beckhoff are optimized for
industrial applications. SSDs from Beckhoff have a considerably higher lifetime expectancy than
commercially available SSDs.
Data transmission before replacement
If you want to exchange a storage medium according to Beckhoff's recommendation, you must copy the data
from the old to the new storage medium. You can use the Beckhoff Service Tool (BST) for this purpose. BST
is a graphical backup and restore program for PCs with a Windows operating system. You can create an
image of your operating system and use it to back up the operating system. Then you can restore the
created image to a new data carrier. The BST is available on a bootable BST USB flash drive. This includes
Windows and a backup software. Select the size of the BST USB flash drive according to the size of the
backup copy of your operating system. You can then keep the flash drive as a backup copy. For this
purpose, the BST USB flash drives are designed for particularly long data preservation by means of special
flash. For more information on the function of the BST, please refer to the corresponding manual.
If your storage medium is defective and there is no backup, Beckhoff Service can provide you with a fresh
Windows image. For this to be possible, the Beckhoff PC must already have been shipped with a valid
operating system license. After installing the fresh image, the applications must be reinstalled.
Exchange hard disk/SSD
To replace the hard disk or SSD, follow the steps below as shown in Figure 28:
1. Loosen and remove the M4 screw (section A).
42
ity
3.0 V 225 mAh
Version: 2.9
Dimensions
Diameter Height
20.0 mm 3.20 mm
B
Weight
3.1 g
CP22xx