Replacing The Storage Media; Fig. 22 Replacing The Battery - Beckhoff CP6706-0001 Manual

-
+
Fig. 22: Replacing the battery
To dispose of the battery, remove it, tape off the poles and put it in the battery disposal.
7.2.2

Replacing the storage media

For new storage media, please contact your Beckhoff Sales only. Hard disks from Beckhoff are optimized for
industrial applications. SSDs from Beckhoff have a considerably higher lifetime expectancy than
commercially available SSDs.
Data transmission before replacement
If you want to exchange a storage medium according to Beckhoff's recommendation, you must copy the data
from the old to the new storage medium. You can use the Beckhoff Service Tool (BST) for this purpose. BST
is a graphical backup and restore program for PCs with a Windows operating system. You can create an
image of your operating system and use it to back up the operating system. Then you can restore the
created image to a new data carrier. The BST is available on a bootable BST USB flash drive. This includes
Windows and a backup software. Select the size of the BST USB flash drive according to the size of the
backup copy of your operating system. You can then keep the flash drive as a backup copy. For this
purpose, the BST USB flash drives are designed for particularly long data preservation by means of special
flash. For more information on the function of the BST, please refer to the corresponding manual.
If your storage medium is defective and there is no backup, Beckhoff Service can provide you with a fresh
Windows image. For this to be possible, the Beckhoff PC must already have been shipped with a valid
operating system license. After installing the fresh image, the applications must be reinstalled.
Replacing the CFast
Chapter 7.2 Maintenance [} 32] shows how to access the CFast.
To replace the CFast, follow the steps shown below in Fig. 23:
1. Press lightly on the CFast, like on a button (section A).
ð When you release the CFast, the push-pull mechanism guides the CFast out of the slot far enough
for you to grab it (section B).
2. Pull the CFast out of the PC (section C).
3. Insert the new CFast into the PC in the same orientation until it protrudes just a bit from the PC.
4. Press the CFast into the PC.
ð You have replaced the CFast.
CP6706-0001 Version: 2.0
Maintenance
35