Commissioning; Switching On The Monitor And Video Source; Avoiding Image Sticking - Eizo CuratOR LL550W Instructions For Use Manual

6 Commissioning

Note
Factory settings
All monitors are optimally preset in the factory, such that changes are not usually required.

6.1 Switching on the monitor and video source

The monitor and connected video source can be switched on in any order.
Switching on the monitor before the video source
1. Switch on the monitor.
The operation LED lights up yellow.
2. Switch on the video source.
If the connected signal can be displayed on the monitor, the operation LED will light
green.
Switching on the video source before the monitor
1. Switch on the video source.
2. Switch on the monitor.
If the connected signal can be displayed on the monitor, the operation LED will light
green.
CAUTION
Operation LED does not light green?
If the operation LED does not light green after the equipment has been switched on and a
video signal has been applied:
• check the system for basic connection and operating errors before contacting service
personnel.

6.2 Avoiding image sticking

Image sticking may occur with LCD monitors. Image sticking is an effect whereby a faint im-
age of the previous screen contents can be seen after the display contents have changed.
The following measures can reduce or prevent image sticking:
• Use a screen saver with regularly changing images
• Switch off the monitor when it is no longer needed.
• The monitor has an energy saving mode:
If the application in use supports the energy saving mode, activate it.
CuratOR LL550W
Instructions for Use, 02/2024
6.1 Switching on the monitor and video source
Commissioning
23