Avoiding Image Sticking; Adjusting The Image Geometry; Adjusting The Brightness And Contrast - Eizo SCD 19102 Instruction Manual

7.4.1

Avoiding image sticking

So-called image sticking may occur with TFT displays. Image sticking is an effect whereby a
faint image of the previous screen contents can be seen after the display contents have
changed. The following measures can reduce or prevent image sticking:
● Use a screen saver with regularly changing images
● Switch off the display when it is no longer needed.
● The display has a power saving mode:
● Activate the power saving mode if it is supported by the application being used.
7.4.2

Adjusting the image geometry

The display automatically recognizes the applied standard, and set-up values for each
standard are preprogrammed. However, depending on the graphics card used, it may still be
necessary to align and size the picture for the selected standard.
7.4.3

Adjusting the brightness and contrast

The brightness and contrast must be adjusted for the respective graphics card (different
output levels) in the system on site.
CAUTION
Brightness and contrast can only be set accurately using a photometer (Serial Spot Meter,
Serial Luminance Meter, Universal Serial Luminance Meter, Advanced Serial Luminance
Meter).
CAUTION
Fine adjustment of analog inputs: only via 15-pin Sub-D and DVI-I sockets
Fine adjustment of digital input: not necessary
• Fine adjustment of the Flat Panel Display should only be carried out via the two analog
• The digital input (DVI-D) does not require a fine adjustment since the signal display is
SCD 19102 / SMD 19102
Instruction Manual, 10/2011, A5E01588521A-004
ports (15-pin Sub-D and DVI-I).
always optimum. With a fine adjustment, it is possible that gray scales are not displayed.
Commissioning
7.4 System settings
61