Chapter 3: System Setup; Removing The Chassis Cover - Nexcom NDiS B561S User Manual

Chapter 3: System Setup

C 3: s
haPter ystem

Removing the Chassis Cover

Prior to removing the chassis cover, make sure the unit's power
is off and disconnected from the power sources to prevent
CAUTION! CAUTION!
CAUTION!
electric shock or system damage.
The expansion modules mentioned in this chapter are
foolproof and can only be installed in one direction. If you
encounter difficulty, try reversing the module's orientation and
avoid using force to prevent damage.
While the images in this chapter may vary, the features and
functionalities described remain the same
Copyright © 2023 NEXCOM International Co., Ltd. All Rights Reserved.
s
etuP
28
1. To install the expansion or memory modules, refer to the following images
to locate the screws. The screws on the front, rear, and bottom are used
to secure the cover to the chassis. Remove the screws and put them in a
safe place for later use.
NDiS B561S User Manual