Table of Contents
Advertisement
Operating IntegratorRD Workstations
Initiating a call on a busy channel may result in two ways depending on whether the
option, Trunk outgoing calls when busy, is enabled or disabled. If this option is enabled,
the call is trunked to the next available MAP27 channel; otherwise, a busy indication is
displayed.
Terminating a Call
Pressing the Call Discon button on the screen terminates an active voice call.
For all call types, the Call Progress area of the channel box shows the progress of the call
setup. The progress conditions are shown in
Table 13: MAP27 Operation Call Progress Messages
Rad Discon
Indiv
Group
Status OK
SST RX'd
Inv Number
No Number
Alerted
Alerting
Queued
Emergency
Diverted
Rejected
Canceled
Out of Rch
Unit Busy
Call Back
Inv Status
Regroup Proc
Regroup OK
Regroup Fail
Initiating a Site-wide Call
The console allows operator to send a site-wide call by activating an instant call page
button that has been configured to send a site-wide call. Please refer to Series 4000
118
Indication
The connection between the channel card and the radio is not
responding.
An individual call has been set up.
A group call has been set up.
The status transmission was acknowledged.
SST message received – the text of the message is shown in the
Call History window.
The ID entered does not conform to MPT1343 rules.
No ID was entered.
The call unit is alerted.
The call unit is alerting.
A call attempt has been queued.
The emergency call is proceeding.
The call has been diverted.
A call attempt has been rejected (system overload).
The call was aborted/not successful.
Called unit is unavailable (normal or diverted).
The called unit is busy.
Called unit will call back.
The status number sent is invalid.
The radio is currently sending the Dynamic Regroup information
over the air.
The Dynamic Regroup message was successful.
The Dynamic Regroup message failed to complete.
Table
13.
Description
025-9535L
Advertisement
Table of Contents
