Table of Contents
Advertisement
352
4-5. Using the driving support systems
When approaching three-
dimensional objects
The estimated course lines tar-
get flat surfaced objects (such
as the road). It is not possible to
determine the position of three-
dimensional objects (such as
vehicles) using the estimated
course lines and distance guide
lines. When approaching a
three-dimensional object that
extends outward (such as the
flatbed of a truck), be careful of
the following.
Estimated course lines
Visually check the surroundings
and the area behind the vehicle.
In the case shown below, the
truck appears to be outside of
the estimated course lines and
the vehicle does not look as if it
hits the truck. However, the rear
body of the truck may actually
cross over the estimated course
lines. In reality if you back up as
guided by the estimated course
lines, the vehicle may hit the
truck.
Owners Manual_USA_M04041_en
Estimated course lines
Distance guide lines
Visually check the surroundings
and the area behind the vehicle.
On the screen, it appears that a
truck is parking at point
However, in reality if you back
up to point
, you will hit the
truck. On the screen, it appears
that
is closest and
thest away. However, in reality,
the distance to
and
same, and
is farther than
and
.
.
is far-
is the
Advertisement
Table of Contents
