Table of Contents
Advertisement
136
3-2. Opening, closing and locking the doors and tailgate
●
A board is not completely stowed
●
Vehicle speed is approximately 3
mph (5 km/h) or higher
The boards will not automatically
deploy again when vehicle speed
returns to less than 3 mph (5 km/h).
■
If "Running Board Unable to
Deploy" is displayed on the
multi-Information display
The board may not be completely
deployed.
Close and open the door once more
or use the switch inside the vehicle
(P.136) and completely deploy the
board.
■
If "Power Steps Unable to
Retract" is displayed on the
multi-Information display
The boards may not be completely
stowed.
Check that nothing is caught
between the boards and the vehicle.
■
If "Power Steps System Mal-
function See Owner's Manual"
is displayed on the multi-infor-
mation display
The system may be malfunctioning.
Have the vehicle inspected by Toy-
ota dealer.
■
When snow or mud is attached
to the boards or the boards are
frozen
The power running boards may not
operate correctly. Before stepping
on a board, check that it is com-
pletely deployed. If the power run-
ning boards are not operating
correctly, turn the power steps
switch off and refrain from use.
■
After recharging/reconnecting
the battery
If the power running boards have
not completely deployed or stowed,
the boards may not move in the
intended direction the first time they
are operated. However, from the
second time onwards, the boards
will resume normal operation.
Owners Manual_USA_M04041_en
■
When getting in and out of the
vehicle
Take care because clothes and
shoes may become dirty due to con-
tact with the lower part of the vehicle
body.
Deploying and stowing
the power running boards
from inside
1
Deploys the running boards
on both sides.
2
Stows the running boards on
both sides.
Putting the switch in the neutral
position sets the power running
boards to AUTO mode. AUTO
mode allows the deploying/stowing
of the boards to be linked to open-
ing/closing of the side doors.
Both power running boards are
deployed when "OUT" position is
selected. Operation only if steps
are not already deployed.
Both power running boards are
stowed when "OFF" position is
selected. Operation only if steps
are not already stowed.
■
Automatic stowing function
The boards will be automatically
stowed, for safety, under the follow-
ing condition:
Advertisement
Table of Contents
