Table of Contents
Advertisement
when they are wearing a raincoat,
long skirt, etc.)
• When a pedestrian is bending for-
ward or squatting
• When a pedestrian or bicycle is
moving at high speed
• When a pedestrian is pushing a
stroller, wheelchair, bicycle or
other vehicle
• When a detectable object blends
in with the surrounding area, such
as when it is dim (at dawn or dusk)
or dark (at night or in a tunnel)
• When the vehicle has not been
driven for a certain amount of time
after the engine was started
• While turning left/right or a few
seconds after turning left/right
• While driving around a curve and
a few seconds after driving around
a curve
• When turning left/right and an
oncoming vehicle is driving in a
lane 3 or more lanes from the
vehicle
• When turning left/right and the
direction of the vehicle differs
greatly from the direction traffic
flows in the oncoming lane
• When turning left/right, a pedes-
trian or bicycle behind the vehicle
comes in front of it as if it over-
takes the vehicle
• When at an intersection, the
approaching crossing vehicle is
Owners Manual_USA_M04041_en
4-5. Using the driving support systems
long in overall length, such as a
large truck, towing trailer, etc.
●
In addition to the preceding, in
certain situations, such as the fol-
lowing, the emergency steering
assist may not operate properly:
• When a detectable object is too
close to the vehicle
• When there is insufficient space to
perform evasive steering maneu-
vers or an obstruction exists in the
evasion direction
• When there is an oncoming vehi-
cle
●
Vehicles with automatic transmis-
sion: In addition to the preceding,
in certain situations, such as the
following, walls may not be
detected as a target object and
the Acceleration Suppression at
Low Speed function may not oper-
ate properly:
• When scenery behind the wall is
visible, such as a glass door, grid
fence, etc.
• When the wall is slanted or low
• When the wall is narrow, such as
a pole, etc.
• When the wall is made of plants,
such as a hedge, etc.
• When the road, etc. is reflected on
the wall
• When the vehicle is approaching
the wall at an angle
Changing the pre-colli-
sion setting
The pre-collision system can
be enabled/disabled through
a customize setting. (P.635)
The system is enabled each time
the engine switch is turned to ON.
When the system is disabled,
the PCS warning light will illu-
minate and a message will be
displayed on the multi-infor-
mation display.
263
4
Advertisement
Table of Contents
