Toyota Tacoma 2024 Manual page 234

236
4-3. Operating the lights and wipers
2
Turn the headlight switch to
the or
When the headlight switch lever is
in the low beam position, the AHB
system will be enabled and the
AHB indicator will illuminate.
■
Automatic operating condi-
tions of the high beams
●
When all of the following condi-
tions are met, the high beams will
illuminate automatically:
• The vehicle speed is approxi-
mately 21 mph (34 km/h) or more.
• The area ahead of the vehicle is
dark.
• There are no vehicles ahead with
lights on.
• There are few streetlights or other
lights on the road ahead.
●
If any of the following conditions
are met, the headlights will
change to the low beams:
• Vehicle speed drops below
approximately 17 mph (27 km/h).
• The area ahead of the vehicle is
not dark.
• There is a vehicle ahead with
lights on.
• There are many streetlights or
other lights on the road ahead.
■
Front camera detection
●
In the following situations, the high
beams may not be automatically
changed to the low beams:
• When a vehicle cuts in front of
your vehicle
• When another vehicle crosses in
Owners Manual_USA_M04041_en
• When vehicles ahead are repeat-
position.
• When a vehicle ahead
• When a vehicle ahead is far away
• When a vehicle ahead has no
• When the lights of a vehicle ahead
• When a vehicle ahead is reflecting
• Situations in which the sensors
●
●
●
• The brightness of lights of vehi-
• The movement and direction of
• The distance between the vehicle
• When a vehicle ahead only has
• When a vehicle ahead is a two-
• The condition of the road (gradi-
• The number of passengers and
●
●
●
front of the vehicle
edly detected and then hidden
due to repeated curves, road
dividers or roadside trees
approaches from a far lane
lights
are dim
strong light, such as own head-
lights
may not operate properly: P.249
The headlights may change to the
low beams if a vehicle ahead that
is using fog lights without its head-
lights turned on is detected.
House lights, street lights, traffic
signals, and illuminated billboards
or signs may cause the high
beams to change to the low
beams, or the low beams to
remain on.
The following may change the tim-
ing at which the headlights
change to the low beams:
cles ahead
vehicles ahead
and a vehicle ahead
lights illuminated on one side
wheeled vehicle
ent, curve, condition of the road
surface, etc.)
amount of luggage
The headlights may change
between the high beams and low
beams unexpectedly.
Bicycles and other small vehicles
may not be detected.
In the following situations, the sys-
tem may not be able to correctly