Before You Begin - Horizon Fitness MATRIX ICR50 Manual

BEFORE YOU BEGIN

LOCATION OF THE EQUIPMENT
Place the equipment on a level and stable surface away from direct sunlight. The intense UV light can cause
discoloration on the plastics. Locate your equipment in an area with cool temperatures and low humidity. Please
leave a clear zone on all sides of the equipment that is at least 60 cm (2 ft). This zone must be clear of any obstruction
and provide the user a clear exit path from the machine. Do not place the equipment in any area that will block any
vent or air openings. The equipment should not be located in a garage, covered patio, near water or outdoors.
MOVING THE EQUIPMENT
Your equipment has a pair of transport wheels built into the front stabilizer tube. To move,
firmly grasp the steel portion of the rear stabilizer tube, carefully lift and roll on the transport
wheels. Remove the power supply before attempting to move the bike.
WARNING!
Our equipments are heavy, use care and additional help if necessary when
moving. Failure to follow these instructions could result in injury.
LEVELING THE EQUIPMENT
It is extremely important that the levelers are correctly adjusted
for proper operation. Turn leveling foot clockwise to lower and
counter-clockwise to raise unit. Adjust each side as needed
until the equipment is level. An unbalanced unit may cause belt
misalignment or other issues. Use of a level is recommended.
FREE AREA
0.6 (2 )
m ft
PROPER USAGE
1. Sit on the cycle facing the handlebars.
Both feet should be on the floor
one on each side of the frame.
2. To determine proper seat position, sit on
the seat and position both feet on the
pedals. Your knee should bend slightly at
the furthest pedal position. You should be
able to pedal without locking your knees
or shifting your weight from side to side.
3. Adjust pedal straps to desired tightness.
4. To get off of the cycle, follow the
proper usage steps in reverse.
7