Position Settings; Advanced Settings; Figure 3-13; Figure 3-14 - Viavi AVX-10K Operation Manual

Manual Mode is used to target a specific aircraft under test when the aircraft under test is
being tested while on the ground or in a multi-path environment.

3.2.6 Position Settings

This setting allows you to set the position data (LAT/LONG) used for ADS-B Auto, ADS-B
Mon, GICB applications, and both the 1090 and UAT Target Gen applications.You can
select USER ENTRY or VIA GPS RX. The GPS Receiver will allow you to use your local
position. If needed, you can obtain your position using the GPS RX functionality of the
AVX- 10K. GPS Position Format can be set to be displayed in Degrees, Degrees Minutes,
or Degrees Minutes Seconds.

3.2.7 Advanced Settings

• Check All UUT Capability – for Transponder and ADS-B applications, all test
parameters the UUT is capable of will be tested. This is typically always set to Yes.
• ADS-B Auto DF Setting – Choose DF17 (typical – for Mode S transponders) or DF18
(1090MHz emitters). Most often this should be left as DF17. The DF18 option is used for
beacons placed on obstacles around airports or in vehicles that are travelling around
aircraft.
22135254
January 2024
Figure 3-13 UUT Address
Figure 3-14 Position Settings
AVX-10K Operaton Manual
Chapter 3 Test Application Common Settings/Steps
Common Setup Parameters
Rev 004
3 - 9