Table of Contents
Advertisement
Remove the phosphor storage plate and pre-
❯
pare to take a new X-ray.
Peel the barrier film and discard it.
❯
If applicable, scan any more phosphor storage
❯
plates that need to be scanned.
After the last phosphor storage plate click Fin-
ish image acquisition.
10.5
Erasing the phosphor storage
plate
The image data is erased automatically after
scanning.
The special ERASE mode only activates the era-
sure unit of the phosphor storage plate scanner.
No image data is scanned.
The phosphor storage plate needs to be erased
using the special mode in the following cases:
– The first time the phosphor storage plate is
used or if it is stored for more than one week.
– Due to an error, the image data on the phos-
phor storage plate has not been erased (soft-
ware error message).
Select the special ERASE mode in the soft-
❯
ware.
Insert the phosphor storage plate (see "Scan-
❯
ning the PSP").
2144100140L29
G8802
2310V007
10.6
Switching the unit off
Tap the On/Off switch
❯
The On/Off button lights up briefly and the
device powers down.
As soon as the unit has shut down it switches
off completely.
After switching off the unit, wait 10 sec-
onds before switching the unit on again.
In case of malfunction, a hard power-down of
❯
the unit can be done. For this purpose, tap the
On/Off button for 5 seconds
In response, the unit powers down immedi-
ately.
Using the dust cover
The dust cover protects the device against dirt
and dust during extended periods in which it is
not used.
WARNING
Danger of suffocation
Store the dust cover out of the reach
❯
of children.
Pull the dust cover over the device until it is
❯
completely covered. Make sure that the mark-
ings are at the front.
Usage
to turn the device Off.
.
EN-US
|
33
Advertisement
Table of Contents
