Installation
7.2
Electrical connection
Electrical safety when making connections
Connect the device to a correctly installed
❯
power outlet only.
Do not place non-fixed multi-socket units on
❯
the floor. Comply with the requirements in sec-
tion 16 of IEC 60601-1 (EN 60601-1).
Do not operate any other systems using the
❯
same multiple socket.
Make sure that none of the electrical cables
❯
leading to the unit are under any mechanical
tension.
Before initial start-up verify that the mains sup-
❯
ply voltage and the voltage stated on the type
plate match (see also "4. Technical data").
Connecting the unit to the mains supply
The unit has no main power switch. For
this reason, it is important to set up the
unit properly such that the plug can be
easily accessed and unplugged if
required.
Requirements:
ü Properly installed power outlet close to the unit
(observe the max. length of the power cord)
ü Easily accessible power outlet
ü Mains voltage matches the information shown
on the type plate of the power supply unit
Only the released power supply units may
be used:
9000150006 EM1024KR or
9000101790 TR30RDM240
Attach the matching country-specific mains
❯
cable to the power supply unit.
20
|
EN-US
Remove the cover on the rear of the device
❯
using a suitable tool (e.g. slot screwdriver).
Plug the connecting plug of the power supply
❯
unit into the connection socket of the unit.
Plug the mains plug into the power outlet.
❯
2144100140L29
G8802
2310V007