Ised Statement - Air Techniques ScanX Swift 2.0 Installation And Operating Instructions Manual

Important information
particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning
the equipment off and on, the user is encouraged
to try to correct the interference by one or more
of the following measures:
Reorient or relocate the receiving antenna.
❯
Increase the separation between the equip-
❯
ment and receiver.
Connect the equipment into an outlet on a cir-
❯
cuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV
❯
technician for help.
Module Compliance FCC
The device contains the RFID module with the
following ID:
– FCC ID: 2ATTE-2144100082
– IC ID: 25412-2144100082
This module has been tested and found to com-
ply with the following requirements for Modular
Approval.
– Part 15.225 - Operation within the band
13.110 - 14.010 MHz.
– Part 2.1046 - Measurements required: RF
power output
Antennas
This radio transmitter has been approved by the
FCC and ISED to operate with the antenna types
listed below with the maximum permissible gain
indicated.
Antenna types not included in this list, having a
gain greater than the maximum gain indicated for
that type, are strictly prohibited for use with this
device.
Radio Antenna
Type
NFC Loop
RF exposure statement
1. This Transmitter must not be co-located or
operating in conjunction with any other
antenna or transmitter.
2. This equipment complies with FCC RF radia-
tion exposure limits set forth for an uncontrol-
led environment. This equipment should be
installed and operated with a minimum dis-
tance of 20 centimeters between the radiator
and your body.
6 | EN-US
2.7
EN:
This device contains licence-exempt transmit-
ter(s)/receiver(s) that comply with Innovation, Sci-
ence and Economic Development Canada's
licence-exempt RSS(s). Operation is subject to
the following two conditions:
– This device may not cause interference.
– This device must accept any interference,
FR:
L'émetteur/récepteur exempt de licence contenu
dans le présent appareil est conforme aux CNR
d'Innovation, Sciences et Développement écono-
mique Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée
aux deux conditions suivantes :
– l'appareil ne doit pas produire de brouillage, et
– l'utilisateur de l'appareil doit accepter tout
RF exposure statement
EN:
Caution: Exposure to Radio Frequency Radiation
1. To comply with the Canadian RF exposure
2. To comply with RSS 102 RF exposure com-
Frequency
FR:
Attention: exposition au rayonnement radiofré-
quence
13,56 MHz
1. Pour se conformer aux exigences de confor-
2. Pour se conformer aux exigences de confor-

ISED Statement

including interference that may cause unde-
sired operation of the device.
brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre
le fonctionnement.
compliance requirements, this device and its
antenna must not be co-located or operating
in conjunction with any other antenna or
transmitter.
pliance requirements, a separation distance
of at least 20 cm must be maintained
between the antenna of this device and all
persons.
mité RF canadienne l'exposition, cet appareil
et son antenne ne doivent pas être co-local-
isés ou fonctionnant en conjonction avec une
autre antenne ou transmetteur.
mité CNR 102 RF exposition, une distance
de séparation d'au moins 20 cm doit être
maintenue entre l'antenne de cet appareil et
toutes les personnes.
2144100140L29 G8802 2310V007