Table of Contents
Advertisement
7
Installation
7.1
Fitting the sensor holder
The sensor holder and the cable holder can be
secured to the wall or treatment unit using either
the adhesive pad or screws and dowel.
The sensor holder can also be fitted to the lamp
stand using the Velcro strip.
Fastening the sensor holder with screws
Use screws and dowel which are suited
to the base surface.
Screw the screws into the wall with the same
❯
spacing as between the slits. Insert the screw
only to the extent such that the screw head
can be hooked into the slits.
Place the sensor holder on the screw heads
❯
from above.
2121100020L29 2101V007
Fastening the sensor holder with the adhesive
pad
Fastening the sensor holder using the Velcro
strip
Thread the Velcro strip into the sensor holder.
❯
Fasten the sensor holder with the Velcro strip.
❯
7.2
Electrical connection
Combining devices safely
Take care when connecting units together or to
parts of other systems as there is always an ele-
ment of risk (e.g. due to leakage currents).
Only connect units when there can be no
❯
question of danger to operator or to patient.
Only connect units when it is safe to do so and
❯
when there is no risk of damage or harm to the
surroundings.
If it is not completely clear from the data sheet
❯
of the unit that such connections can be safely
made or if you are in any doubt, always get a
suitably qualified person (e.g. the relevant man-
ufacturer) to verify that the setup is safe.
Installation
EN-
US
17
Advertisement
Table of Contents
