Table of Contents
Advertisement
Setup and installation
8.6.3
Mains connection
Laser rack and PC have a cold device socket on the rear for the cold device cables supplied.
Before commissioning, it is essential to check whether the laser rack is configured to the mains voltage and frequency.
The configuration of the laser rack is given on the type plate or on the warning label above the IEC connector.
Warning Dangerous electrical voltage
The laser rack is fitted with different main fuses depending on the configured supply voltage:
The main fuses are located behind the cover, immediately adjacent to the IEC connector.
The same main fuse is used on the PC for all mains voltages.
8.6.4
Interface pin configuration
X11 – Safety circuit (Emergency stop button / interlock safety switch / external messages)
X31 - External panel
46
115V AC
230V AC
-
1 x 6.3 A "T" speed/time-delay
-
2 x 4 A "T" speed/time-delay
Advertisement
Table of Contents
