Connections; Connecting The Mains - Trotec Speedy 300 fiber Operation Manual

8017 Trotec Speedy 300 fiber
BEFORE OPERATION

3.7 Connections

Perform the connections exactly in the order described; otherwise
electrostatic charging can damage your computer and/or the electronics of the
laser system.

3.7.1 Connecting the Mains

Connect one end of the mains cable with the connection socket (1) at the rear side
of the laser device (see Figure below) and the other end with a protected power
outlet.
Mains voltage and operating voltage must correspond (AC 230 V/50 Hz
or AC 115 V/60 Hz) – see information label beside the connection
socket.
Under no circumstances switch on the device if the voltages do not
correspond.
The main fuses (2) are located below the connection socket and are
accessible from the exterior.
28/07/2015 Trotec Produktions- und Vertriebs GmbH_Linzer Strasse 156, A-4600 Wels, Austria, Technical Support
tel_+43 (0)7242 239-7000, fax_+43 (0)7242 239-7380, mailto:
INPUT POWER
100-120VAC 60HZ
INPUT POWER
220-240VAC 50HZ
techsupport@troteclaser.com
1
2
21 / 54