Connections; Connecting The Mains - Trotec Speedy 400 flexx Operation Manual

3.7

Connections

Perform the connections exactly in the order described, otherwise
electrostatic charging can damage your computer and/or the
electronics of the laser system.

3.7.1 Connecting the Mains

Connect one end of the mains cable with the connection socket (1) at the rear side
of the laser device (see Figure below) and the other end with a protected power
outlet.
Mains voltage and operating voltage must correspond (AC 230 V/50
Hz or AC 115 V/60 Hz) - see information label beside the connection
socket.
Under no circumstances switch on the device if the voltages do not
correspond.
The main fuse (2) is located below the connection socket and is
accessible from the exterior.
8026 | V5.0_EN (11/2015)
Technical changes reserved
INPUT POWER
220-240VAC 50HZ
Trotec Laser GmbH
INPUT POWER
100-120VAC 60HZ
1
2
Page 22 of 62