Safety; General Safety Notes - Trotec SpeedMarker 700 FL Operating Manual

3

Safety

TO AVOID POSSIBLE HARM READ AND FOLLOW THESE INSTRUCTIONS.
The machine is built at the time of it's development and production according to applicable, established technical rules
and is considered to be safe to operate.
Dangers can be caused by the machine if the machine:
is operated by unqualified personnel,
•
the personnel have not been trained,
•
the machine is used improperly or not as intended,
•
or if the machine is used for other intended purposes.
•
This chapter provides an overview of all important safety aspects that are necessary for optimum protection of persons
and safe and trouble-free operation of the machine. Other chapters of this manual contain specific safety notes for the
avoidance and prevention of hazards.
3.1

General safety notes

GENERAL SAFETY NOTES:
Only trained persons may perform activities on the machine.
•
Safety devices, protective devices and machine parts must be present and must not be bridged. Faultless and
•
intended function must be ensured.
Work and control of the machine only by persons with sufficient knowledge of the function of the machine (applies
•
especially to service operation).
Never leave the machine unattended during operation. When the machine is not in use, turn off the main switch.
•
Replace detached or damaged machine signage immediately.
•
In the event of an unmanageable malfunction, switch off the machine and contact technical support in order not to
•
damage the machine.
The use of inferior spare parts or third-party components impairs the safety of the machine and renders the
•
declaration of conformity (CE) supplied invalid.
Protective equipment:
•
Wear suitable work clothing and protective goggles matched to the laser (laser class 4).
Exhaust system:
•
Use suitable extraction equipment, as gases, fumes and other partially toxic by-products may be generated.
Materials:
•
Select suitable parameters for the corresponding material. Safely extract dusts so that no detectable residues or
residues can collect in the work area.
Safety
13