Table of Contents
Advertisement
6.2.2
Hysteresis setting
To prevent chattering of an alarm output near the alarm setting values, set hysteresis.
(1) During measurement, press the
the
key. Press the
(2)
the
key, and press the
Enter a numeric value by using the
or the
key.
To close "Hysteresis Setting"
To close the "Hysteresis Setting" or cancel
the mode midway, press the
A previous screen will return.
Setting range
0 to 20% of full scale
A full scale means each range provides a full
scale of width.
Hysteresis
the upper limit value is exceeded.
Hysteresis width
INZ-TN6ZAF-E
key to
MODE
key.
ENT
key.
ENT
key, and then press the
key.
ESC
Alarm
User Mode
or
Setting about Calibration
Alarm Setting
Setting of Auto Calibration
Changeover of Range
Parameter Setting
Alarm Setting
or
,
Upper
ENT
DO3
Lower
DO3
Kind of Alarm
Hysteresis
ON/OFF
Select an item
with UP/DOWN and ENT
Back with ESC
Select an item
with UP/DOWN and ENT
Back with ESC
Renge 1
0.900 vol%
Renge 2 03.00 vol%
Renge 1
0.200 vol%
Renge 2 01.00 vol%
Upper+Lower
00%FS
OFF
Upper limit value
ON (conductive)
OFF (open)
-
29
Advertisement
Table of Contents
