Graco Therm-O-Flow 200 Instructions-Parts List Manual page 110

Appendix A - ADM
Heat - A
Use these screens to set target and setback
temperatures for the Pump, Platen, and zones. Select
which system needs to use the heated accessory.
Zone Types:
• Hose
• Gun
• PGM
• Flowmeter
• Pressure Regulator
• Manifold
• Other
NOTE: To ensure accurate hose and gun temperatures,
set hose as zone 1, 3, 5, 7, 9, or 11 when connected to
MZLP and a heated hose.
110
Maintenance - A
The system will notify the user at the set interval that
maintenance is required. The fields in boxes can be
edited by the user. "Due" and "Current" are both the
number of cycles since the last reset. "Interval" is the
set number of cycles between maintenance
notifications. "Lifetime" is the number of cycles in the
lifetime of the system.
NOTE: The lifetime cycle count will only be reset if the
ADM is replaced.
Schedule
Use this screen to set times that the system will
automatically enable and disable heating. See
Schedule, page 36.
334130W