Graco Therm-O-Flow 200 Instructions-Parts List Manual page 100

Accessories and Kits
4. Remove the screws (B), the plate (A), and the
gasket (C) from the system. Use the screws (2) to
install the MZLP (1) onto the system as shown.
NOTE: The new MZLP (1) will be refereed to as MZLP2,
and the original MZLP that came with the system will be
referred to as MZLP 1.
5. Open the Electrical Enclosure door.
NOTE: Do not force the electrical connection. Minimal
force is required to seat the connector. If resistance is
felt, stop, and verify the connector orientation.
6. Connect the cable (4) to the J3 connector on MZLP
1 and the J6 connector on MZLP 2.
7. Connect the power harness (6) to the MZLP 2 J2
connector and the J5 connector on the AWB. Install
the jumper (5) on the MZLP 2 J5 connector.
8. Use fittings and hoses that meet your hose routing
needs. See Accessories and Kits, page 94.
9. To ensure your system has the latest software,
insert the token (8) into the ADM. See Update
Software, page 60.
100 334130W