Update Software - Graco Therm-O-Flow 200 Instructions-Parts List Manual

Repair

Update Software

When software is updated on the ADM, the software is
then automatically updated on all connected GCA
components. A status screen is shown while software
is updating to indicate progress.
1. Turn the system Main Power Switch OFF.
2. Remove the ADM from the bracket.
3. Remove the token access panel.
4. Insert and press the software upgrade token (T)
firmly into the slot.
NOTE: There is no preferred orientation of the token.
T
5. Install the ADM into the bracket.
6. Turn the system Main Power Switch ON.
NOTICE
A status is shown while software is updating to
indicate progress. To prevent corrupting the
software load, do not remove the token until the
status screen disappears.
60
NOTE: When the Screen turns on, you will see the
following screens:
First:
Software is checking
which GCA modules will
take the available updates.
Second:
Status of the update with
approximate time until
completion.
Third:
Updates are complete.
Icon indicates update
success/failure. See the
following Icon table.
Icon Description
Update successful.
Update unsuccessful.
Update complete, no changes necessary.
Update was successful/complete, but
one or more HCA modules did not have a
CAN boot-loader, so software was not
updated on that module.
7. Remove the token (T).
8. Replace the token access panel.
9. Press to continue to the operation screens.
334130W