Prime Pump - Graco Therm-O-Flow 200 Instructions-Parts List Manual

Prime Pump

1. Ensure that the system has completed the heat
soak cycle. The display status bar should read
Active.
2. Adjust the Air Motor Air Regulator (CK) to 0 psi.
334130W
3. Adjust the Air Motor Slider Valve (CM) to the open
4. Adjust the Air Motor Air Regulator (CK) to
CK
CN
5. Place a waste container under the bleed stem (Z).
position.
approximately 20 psi (138 kPa, 1.38 bar).
Using an adjustable wrench, open the bleed stem
counterclockwise 1/3 -1/2 turn.
Operation
CM
CK
Z
31